Tn2501Ap Voice Over The Lan (Val) - Avaya S8700 Manual

2
If step 1 passes, type ping ip-address ipaddress board UUCSS and press
is the IP address of the customer's gateway.
3
If step 2 passes, type ping ip-address ipaddress board UUCSS and press
is the IP address of a computer beyond the gateway.
The TN2302AP IP Media Processor is now installed in the media gateway and connected to the IP
network.

TN2501AP Voice over the LAN (VAL)

The TN2501AP Voice over the LAN (VAL) is an integrated announcement circuit pack that uses *.wav
files for announcements and plays them over the TDM bus. It can store up to 1 hour of announcement
storage capacity.
Install a TN2501AP VAL
Installing the pack includes:
•
Verifying the required hardware
•
Install the Circuit Packs
•
Administer the TN2501AP
Verifying the required hardware
Make sure that you have the required hardware:
•
TN2501AP VAL circuit pack (108772583).
•
10/100BaseT backplane adapter (848525887—same one used for the IP Media Processor). See
Backplane Adapter
•
Tight-twisted I/O cable kit (700181118) only if installing in old carriers or cabinets with WP
cables.
•
LAN cable with RJ45 connectors (customer supplied).
Adding New Hardware--S8700
November 2003
NOTE:
The P board suffix designation means the circuit pack is firmware-downloadable. Click
the Upgrading tab above and go to "Upgrade Firmware on Programmable Circuit Packs"
for more information.
NOTE:
To install a TN2501AP, make sure that the system is enabled for TN2501AP (VAL)
boards. If the Maximum VAL boards field on the Customer Options screen is set to 0,
then you need to obtain and install a new license file before you can install the card.
on page 25
on page 26
on page 27
on page 26.
Install and Administer IP Connectivity Hardware
Enter
Enter
, where ipaddress
, where ipaddress
25