Avaya S8700 Manual page 63

Figure 13: Connecting directly to the IPSI
cadlipsi KLC 031502
Figure notes
1 Services laptop
2 PCMCIA Network Interface Card (NIC)
Reusing a TN2312AP/BP circuit pack
1
Plug the circuit pack into the appropriate slot in the media gateway or if already plugged in, reseat
it (unplug and plug in).
2
While the letters I P are flashing on the LED display (5 seconds), press the recessed pushbutton on
the faceplate.
3
The circuit pack is now ready for a new static IP address.
Administering the static IP address
1
Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2
From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3
Type command and press
Adding New Hardware--S8700
November 2003
1
CAUTION:
If reusing TN2312AP or TN2312BP circuit packs that have previously had a static address
programmed, you must erase the existing IP address before programming another one.
Failure to do this may result in serious network problems for the customer. Use the
following procedure to erase an existing IP address assignment:
NOTE:
Make sure you have the password before proceeding.
Enter
2
3
3 NIC adapter cable (if necessary)
4 CAT5 crossover cable to IPSI
to open a MS-DOS Command Line window.
Adding a port network
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
4
63