Avaya S8700 Manual page 65

10
Type show control interface and press Enter.
The IP address, subnet mask, and default gateway information will be displayed.
Verify that the proper information was entered.
11
If required, type set control gateway gateway and press Enter, where gateway is the
customer-provided IP address for their gateway.
12
Press
Enter
13
If required, use the set vlan priority, set vlan tag, set vlan id and set diffserv commands to
enter VLAN and diffserv parameters for the IPSI. Use Help to obtain syntax guidelines for these
commands.
14
Type reset and press
Answer Y to the warning.
15
Type quit to logoff the IPSI.
16
Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See
LED display showing that the IPSI has a static IP address,
Figure 14: LED display showing that the IPSI has a static IP address
17
Disconnect the laptop from the faceplate.
18
Repeat for each IPSI circuit pack.
Adding New Hardware--S8700
November 2003
to effect the changes.
Enter
NOTE:
Resetting the IPSI terminates the administration session. If further administration is
required, start a new telnet session to the IPSI.
NOTE:
Control network settings (IP address, subnet mask, and gateway) become effective when
you exit the IPADMIN session.
NOTE:
Always use the arp -d 192.11.13.6 command (step 4) to clear the ARP cache on the
laptop before connecting to another IPSI. If the cache is not cleared the laptop appears to
hang and does not connect to the next IPSI.
on page 65)
CLK
S
E
R
V
Adding a port network
Figure 14,
65