Avaya S8700 Manual page 28

Install and Administer IP Connectivity Hardware
4
Type a unique name in the Name field.
This name is recognized only within the Communication Manager and does not need to match the
node name on your network.
5
Enter the IP Address.
Get this information from the project manager or the customer's network administrator.
6
Press
Enter
7
Type change ip-interface
change ip-interface 07B09
Gateway Address: 172.16 .23 .254
Enable Ethernet Port? y
Network Region: 8
8
Type in the following information:
•
•
•
•
•
•
•
9
Press
Enter
10
Type add data-module extension and press
add data-module next
Data Extension: 20010
Network uses 1's for Broadcast Addresses? y
28
to save the changes.
UUCSS and press Enter.
Type: VAL
Slot: 07B09
Code/Suffix: TN2302
Node Name: VAL#1
IP Address: 172.22 .22 .120
Subnet Mask: 255.255.255.0
VLAN: n
The Type, Slot, IP Address, and Code/Suffix fields are automatically populated.
In the Node Name field type the same node name entered on the Node Name screen.
In the Subnet Mask field use the default setting unless you are given a different subnet
mask.
In the Gateway Address field use the address you are given or leave blank.
Set the Enable Ethernet Port field to y
Set the Net Region field to 1 unless you are given a different number.
Set VLAN to n
to save the changes.
DATA MODULE
Type: ethernet
Port: 01Al2
Link:
IP INTERFACES
Enter .
Name:VAL1
Adding New Hardware--S8700
Page 1 of 1
Page 1 of 1
November 2003