Avaya S8700 Manual page 18

Install and Administer IP Connectivity Hardware
1
Insert the TN799DP circuit packs into the port slots identified earlier.
Administer the TN799DP
Use a terminal emulation application or Avaya Site Administration for the administration.
1
Log in as craft.
2
Type list configuration all and press
TN799DP circuit packs.
3
Type change node-name ip and press
change node-names ip
Name
csr1clan1
sr1clan2
traf-clan
( 12 of 12
Use 'list node-names' command to see all the administered node-names
Use 'change node-names ip xxx' to change a node-name 'xxx' or add a node-name
4
Type in the node names and IP addresses for each TN799DP C-LAN circuit pack.
5
Type display circuit-pack
up in the Code column.
6
Type
change ip-interface
change ip-interface 01A11
Gateway Address: 172.16 .23 .254
Enable Ethernet Port? y
Network Region: 8
Number of CLAN Sockets Before Warning: 400
18
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
NOTE:
The customer or design team provides the actual names, IP addresses, subnet masks, and
gateway addresses.
IP Address
192.168.1 .80
172.16 .19 .220
172.16 .19 .118
. . .
. . .
. . .
. . .
administered node-names were displayed )
cabinetnumber and press Enter to verify that the TN799DP shows
UUCSS and press Enter.
Type: C-LAN
Slot: 01A11
Code/Suffix: TN799 D
Node Name: clan1A11
IP Address: 172.16 .19 .118
Subnet Mask: 255.255.255.0
VLAN: n
Enter to verify that Communication Manager recognizes the
Enter .
IP NODE NAMES
Name
IP INTERFACES
Adding New Hardware--S8700
Page 1 of 1
IP Address
. . .
. . .
. . .
. . .
. . .
. . .
. . .
Page 1 of 1
November 2003