Avaya S8700 Manual page 24

Install and Administer IP Connectivity Hardware
6
Type
change ip-interface
change ip-interface 07B09
Gateway Address: 172.16 .23 .254
Enable Ethernet Port? y
Network Region: 8
7
Type in the following information:
•
•
•
•
•
•
•
8
Press
Enter
Refer to the Administration for Network Connectivity for Avaya Communication Manager (555-233-504)
for more information on these administration steps and for the steps to administer endpoints.
Test the external connection to the LAN
To test the external IP connections, ping a computer on the same subnet, the gateway, and a computer
beyond the gateway. If everything is configured correctly, the Result column on the Ping Results
screen reads pass. If it reads abort, verify the IP-address information and check the connectivity,
including the cabling.
1
Type ping ip-address ipaddress board UUCSS and press
address of a computer on the same subnet and UUCSS is the cabinet, carrier, and slot of the
TN2302AP IP Media Processor.
ping ip-address 192.168.10.21
End-pt IP
192.168.10.21
24
UUCSS and press Enter.
Type: MEDPRO
Slot: 07B09
Code/Suffix: TN2302
Node Name: prowler1
IP Address: 172.16 .19 .221
Subnet Mask: 255.255.255.0
VLAN: n
The Type, Slot, IP Address, and Code/Suffix fields are automatically populated.
In the Node Name field type the same node name entered on the Node Name screen.
In the Subnet Mask field use the default setting unless you are given a different subnet
mask.
In the Gateway Address field use the address you are given or leave blank.
Set the Enable Ethernet Port field to y
Set the Net Region field to 1 unless you are given a different number.
Set VLAN to n
to save the information and effect the new settings.
PING RESULTS
Port Port Type
01A13 MEDPRO
IP INTERFACES
Enter
Result Time(ms)
PASS 10
Adding New Hardware--S8700
Page 1 of 1
, where ipaddress is the IP
Error Code
November 2003