Avaya S8700 Manual page 23

Install the circuit packs
1
Insert the TN2302AP IP Media Processor into the port slot you reserved for it and seat it properly.
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The RED
LED stays on until an IP address is assigned to the circuit pack.
Administer the IP Media Processor
Use a terminal emulation application or Avaya Site Administration for the administration.
1
Log in as craft.
2
Type list configuration all and press
TN2302AP circuit packs.
3
Type change node-names and press
4
On page 2, type in the node names and IP addresses for the TN2302AP.
change node-names ip
Name
cognac
default
medpro
prowler
prowler1
prowler2
prowler3
prowler4
prowler5
sr1clan1
sr1clan2
traf-clan
( 12 of 12
Use 'list node-names' command to see all the administered node-names
5
Type display circuit-pack and press
column.
Adding New Hardware--S8700
November 2003
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN2302AP circuit packs are hot-swappable, so you do not need to power down the
media gateway to install them.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
IP Address
172.16 .19 .2
0 .0 .0 .0
192.168.1 .82
192.168.1 .83
172.16 .19 .221
172.16 .19 .222
172.16 .19 .223
172.16 .19 .224
172.16 .19 .225
192.168.1 .80
172.16 .19 .220
172.16 .19 .118
. . .
. . .
. . .
. . .
administered node-names were displayed )
Install and Administer IP Connectivity Hardware
to verify that Communication Manager recognizes the
Enter
.
Enter
IP NODE NAMES
Name
. Verify that the TN2302AP shows up in the Code
Enter
Page 1 of 1
IP Address
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
23