ADC Soneplex Broadband System Operation And Maintenance Manual page 245

ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
DLP-570
Page 12 of 18
FIELD TYPE
BIT ERROR SETUP FIELDS
Error Count Input
Error Rate Toggle
Error Locn Toggle
–
Error Counts Display
Data only
Error Counts – Display
BPV only
Error Counts – Display
Frame only
Error Counts – Display
CRC only
–
Error Counts Display
COFA only
–
Status F Sync Display
only
–
Status P Sync Display
only
–
Status RAI Display
only
2-222
© 2000, ADC Telecommunications, Inc.
Table 570-1. RTAU Configuration Fields, continued
OPTIONS
OVERVIEW: Bit errors can be injected by the RTAU using the
Bit Error Set Up fields. These sections are display-only fields that
are only displayed when the line code setting is INTERNAL. The
Status field always shows the current status if the line code is
INTERNAL, but the Error Counts and Elapsed Time fields only
show a value when a measurement is being made.
Range of 0 to Select either Error Count or Error Rate for bit error setup. Both
1544 cannot be set at the same time. If single errors or a burst of
errors is desired, set the Error Count field to the number of
errors to insert. If the Error Count field is set, the number of
errors will be transmitted each time the Enter key is pressed.
OFF, 1E-3, Select either Error Count or Error Rate for bit error setup. Both
1E-4, 1E-5, cannot be set at the same time. If a steady error rate is desired,
1E-6, 1E-7 set the Error Rate field, which indicates the rate bit or frame
errors are injected.
OVERVIEW: The Error Location field must be set to either
PAYLOAD or FBE if the count or rate field is set. Pressing
the Enter or Return key will cause the RTAU to send the
errors.
N/A Indicates count is 0 and rate is off.
PAYLOAD Bit errors are injected.
FBE Frame Bit Error. Frame errors are injected.
None Eight-digit counter or blank.
None Eight-digit counter or blank.
None Eight-digit counter or blank.
None Eight-digit counter or blank.
None Eight-digit counter or blank.
None * or blank
None * or blank
None * or blank
DESCRIPTION DEFAULT
0
Off
N/A
Blank
Blank
Blank
Blank
Blank
Blank
Blank
Blank
(continued)