Spraying
Spraying
Spraying
The Fusion AP gun is shown.
1. Engage gun piston safety lock and close gun
fluid inlet valves A and B.
Fusion
Fusion
Fusion
2. Attach gun fluid manifold. Connect gun air line.
Open air line valve.
3. Adjust the gun air regulator to desired gun air
pressure. Do not exceed the maximum rated
air pressure.
4. Set PRESSURE RELIEF/SPRAY valves (SA,
SB) to SPRAY
SA
5. Verify heat zones are on and temperatures
and pressures are on target, see
Home screen, page
333023M
Probler
Probler
Probler
.
GB
GA
SB
38.
6. Open fluid inlet valve located at each pump inlet.
7. Press
to start motor and pumps.
8. Check fluid pressure gauges (GA, GB) to
ensure proper pressure balance. If imbalanced,
reduce pressure of higher component by
slightly turning PRESSURE RELIEF/SPRAY
slightly
slightly
valve for that component toward PRESSURE
RELIEF/CIRCULATION
balanced pressures.
SA
Spraying
until gauges show
GB
GA
SB
49