Graco Reactor 2 E-30 Operation page 6

Warnings
EQUIPMENT MISUSE EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
MOVING MOVING PARTS MOVING
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Pressurized equipment can start without warning. Before checking, moving, or servicing
equipment, follow the Pressure
BURN HAZARD HAZARD
BURN BURN HAZARD
Equipment surfaces and fluid that is heated can become very hot during operation. To avoid
severe burns:
• Do not touch hot fluid or equipment.
6
WARNING WARNING WARNING
MISUSE HAZARD MISUSE HAZARD HAZARD
Technical Data Technical
PARTS HAZARD PARTS HAZARD HAZARD
Pressure Relief
Pressure
Data in all equipment manuals. Data
Pressure Relief Relief Procedure Procedure when equipment is not in use.
Pressure Relief Procedure
Relief Procedure Procedure and disconnect all power sources.
Relief Procedure
333023M