Connect Power - Graco Reactor 2 E-30 Operation

Setup

Connect Power

Power
Connect Connect Power
All electrical wiring must be done by a qualified
electrician and comply with all local codes and
regulations.
1. Turn main power switch (MP) OFF.
2. Open electrical enclosure door.
NOTE: Terminal jumpers are located inside the
NOTE: NOTE:
electrical enclosure door.
Table Table 5 5 5 Power Table Power Power Cord Cord Requirements Cord Requirements Requirements
Model Model Model Input Power Input Input Power Power
E-30,
200–240 VAC, 1
10 kW Phase
200–240 VAC, 3
Phase, DELTA
350–415 VAC, 3
Phase, WYE
E-30, 200–240 VAC, 1
15 kW Phase
200–240 VAC, 3
Phase, DELTA
350–415 VAC, 3
Phase, WYE
28
Cord Cord Cord
Specifications*
Specifications* Specifications*
AWG (mm AWG AWG (mm (mm 2 2 2 ) ) )
4 (21.2), 2 wire +
ground/PE
6 (13.3), 3 wire +
ground/PE
8 (8.4), 4 wire +
ground/PE
4 (21.2), 2 wire +
ground/PE
6 (13.3), 3 wire +
ground/PE
8 (8.4), 4 wire +
ground/PE
3. Install supplied terminal jumpers in the positions
shown in image for the power source used.
4. Route power cable through strain relief (EC) in
electrical enclosure.
5. Connect incoming power wires as shown in
image. Gently pull on all connections to verify
they are properly secured.
6. Verify all items are connected properly as shown
in image then close electrical enclosure door.
Model Model Model Input Input Input Power Power Power
E-XP2, 200–240 VAC, 1
15 kW Phase
200–240 VAC, 3
Phase, DELTA
350–415 VAC, 3
Phase, WYE
* Values are for reference only. Refer to amperage
listed in Models table (see
system and compare against latest version of local
electrical code to select proper power cord size.
NOTE: 350–415 VAC systems are not designed to NOTE: NOTE:
operate from 480 VAC power source.
Cord Cord Cord
Specifications*
Specifications* Specifications*
AWG AWG AWG (mm (mm (mm 2 2 2 ) ) )
4 (21.2), 2 wire +
ground/PE
6 (13.3), 3 wire +
ground/PE
8 (8.4), 4 wire +
ground/PE
Models, page 9 ) for given
333023M