Graco Reactor 2 E-30 Operation page 8

Important Isocyanate Information
Material Self Self - - - Ignition Ignition
Material Material Self Ignition
Some materials may become self-igniting if applied
too thick. Read material manufacturer's warnings
and SDS.
Keep Components Components A A A and
Keep Keep Components
Cross-contamination can result in cured
material in fluid lines which could cause serious
injury or damage to equipment. To prevent
cross-contamination:
• Never Never interchange component A and component Never
B wetted parts.
• Never use solvent on one side if it has been
contaminated from the other side.
Changing Materials Materials
Changing Changing Materials
NOTICE
NOTICE NOTICE
Changing the material types used in your
equipment requires special attention to avoid
equipment damage and downtime.
• When changing materials, flush the equipment
multiple times to ensure it is thoroughly clean.
• Always clean the fluid inlet strainers after
flushing.
• Check with your material manufacturer for
chemical compatibility.
• When changing between epoxies and urethanes
or polyureas, disassemble and clean all fluid
components and change hoses. Epoxies often
have amines on the B (hardener) side. Polyureas
often have amines on the B (resin) side.
8
and B B B Separate Separate
and Separate
Moisture Sensitivity Sensitivity of of of Isocyanates
Moisture Moisture Sensitivity
Exposure to moisture (such as humidity) will cause
ISO to partially cure, forming small, hard, abrasive
crystals that become suspended in the fluid.
Eventually a film will form on the surface and the ISO
will begin to gel, increasing in viscosity.
NOTICE
NOTICE NOTICE
Partially cured ISO will reduce performance and
the life of all wetted parts.
• Always use a sealed container with a desiccant
dryer in the vent, or a nitrogen atmosphere.
Never store ISO in an open container.
Never Never
• Keep the ISO pump wet cup or reservoir (if
installed) filled with appropriate lubricant. The
lubricant creates a barrier between the ISO and
the atmosphere.
• Use only moisture-proof hoses compatible with
ISO.
• Never use reclaimed solvents, which may
contain moisture. Always keep solvent
containers closed when not in use.
• Always lubricate threaded parts with an
appropriate lubricant when reassembling.
NOTE: NOTE: The amount of film formation and rate of NOTE:
crystallization varies depending on the blend of ISO,
the humidity, and the temperature.
Foam Resins Resins with with 245
Foam Foam Resins with
Agents
Agents Agents
Some foam blowing agents will froth at temperatures
above 90°F (33°C) when not under pressure,
especially if agitated. To reduce frothing, minimize
preheating in a circulation system.
Isocyanates
Isocyanates
245 fa fa fa Blowing Blowing
245 Blowing
333023M