Startup - Graco Reactor 2 E-30 Operation

Startup

Startup
Startup Startup
To prevent serious injury, only operate Reactor
with all covers and shrouds in place.
NOTICE
NOTICE NOTICE
Proper system setup, startup, and shutdown
procedures are critical to electrical equipment
reliability. The following procedures ensure steady
voltage. Failure to follow these procedures will
cause voltage fluctuations that can damage
electrical equipment and void the warranty.
Check fluid fluid inlet inlet filter filter screens.
1. Check Check fluid inlet filter
Before daily startup, ensure that the
fluid inlet screens are clean. See
Flush Inlet Strainer Screen, page 60
2. Check Check ISO Check ISO lubrication ISO lubrication lubrication reservoir.
Check level and condition of ISO lube daily. See
Pump Lubrication System, page
3. Use A and B Drum Level Sticks (24M174) to
measure the material level in each drum.. If
desired, the level can be entered and tracked in
the ADM. See Advanced Setup Screens, page
44
screens.
screens.
reservoir. reservoir.
61.
Check generator generator fuel
4. Check Check generator
Running out of fuel will cause voltage
fluctuations that can damage electrical
equipment and void the warranty. Do not run
out of fuel.
5. Confirm Confirm Confirm main main main power
generator.
generator. generator.
6. Ensure the main breaker on the generator is in
the off position.
7. Start the generator. Allow it to reach full operating
temperature.
Turn main main power power switch
8. Turn Turn main power
The ADM will display the following screen until
communication and initialization is complete.
34.
fuel level. level.
fuel level.
NOTICE NOTICE NOTICE
power switch power switch is is is OFF switch OFF before OFF before starting before
switch ON. ON.
switch ON.
starting starting
333023M