Lexmark Pro910 Series Service Manual page 32

Lexmark Pro910 Series
Error table
Error
Address error
NVRAM error
Never error
Software detected error
Loop timeout error
2-12
Service Manual
Description
Firmware attempted to access invalid
address space.
An error was detected in reading or
writing NVRAM.
Stack over and under flow error; code
error.
An error condition was detected in the
software control code.
Error detected that a while loop or
similar loop timed out before the event
it was waiting on finished.
Action
Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in. If the problem
remains, then replace the printer.
Service:
Replace the system board. See
"System board removal" on
page 4-35.
Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in. If the problem
remains, then replace the printer.
Service:
Replace the system board. See
"System board removal" on
page 4-35.
Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in. If the problem
remains, then replace the printer.
Service:
Replace the system board. See
"System board removal" on
page 4-35.
Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in. If the problem
remains, then replace the printer.
Service:
Reinstall the print driver. If the
problem remains, then replace the
system board. See "System board
removal" on page 4-35.
Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in.
Service:
Replace the system board. See
"System board removal" on
page 4-35.
Previous
Next
Go Back