Front Cover Removal - Lexmark Pro910 Series Service Manual

Lexmark Pro910 Series

Front cover removal

1.
Remove the following:
a.
Left side cover.
b.
Right side cover. See
c.
System board shield. See
d.
Scanner unit. See
e.
Midframe cover and control panel. See
page 4-38.
Note: Do not detach the control panel from the midframe cover.
f.
USB port/Memory card slot. See
2.
Remove the two screws (A), and release the two latches (B) to detach the front cover.
This is the photo of the front cover.
4-44
Service Manual
See"Left side cover removal" on page
"Right side cover removal" on page
"System board shield removal" on page
"Scanner unit removal" on page
"Midframe cover and control panel removal" on
"USB port/Memory card slot removal" on page
B
A
4-23.
4-25.
4-28.
4-30.
Previous
Next
Go Back
4-41.
Disassembly
Flowchart