Lexmark Pro910 Series Service Manual page 33

Error table
Error
NVRAM control section corrupted
Fax error
Card R/W error
Print carrier stall
Description
Indicates that the control section of
NVRAM is corrupted.
General error in receiving or sending
fax.
Problem reading or writing the media
card.
The printer carrier has stalled.
Lexmark Pro910 Series
Action
Technical Support Center:
The printer will auto reset.
Service:
The printer will auto reset.
Technical Support Center:
Make sure that the standard analog
phone line is active and the line jack is
not damaged. If the problem remains,
then replace the printer.
Service:
Replace the fax card. See "Fax card
removal" on page 4-42.
Technical Support Center:
Remove and reinsert the media
device. If the problem remains, then
replace the printer.
Service:
Check the USB/Memory card slot
using other media devices. If the
problem remains, then replace the
USB/Memory card slot. See
port/Memory card slot removal" on
page 4-41.
Technical Support Center:
1. Check if the ink cartridges are
properly installed.
2. Clear the jam clearance area from
any obstructions.
3. Unplug the printer from the
electrical outlet, wait for 10
seconds, and then plug the printer
back in.
If the problem remains, then replace
the printer.
Service:
Go to "Carrier service checks" on
page 2-14.
Diagnostic information
Previous
Next
Go Back
"USB
2-13