Removal Procedures; Base Printer - Cover Removals; Column Left Front Cover Removal (Mx81X) - Lexmark MX81 series Service Manual

Hide thumbs Also See for MX81 series:
Table of Contents

Advertisement

8
If the printer does not meet the skew specifications, adjust the reference edge as specified in
adjustment" on page
9
Adjust the scanner registration manually as needed in the Configuration menu. See
page
247.

Removal procedures

Keep the following tips in mind as you replace parts:
Some removal procedures require removing cable ties. You must replace cable ties during reassembly to avoid
pinching wires, obstructing the paper path, or restricting mechanical movement.
Remove the toner cartridges, imaging unit, and media tray before removing other printer parts. The imaging unit
should be carefully set on a clean, smooth, and flat surface. It should also be protected from light while out of the
device.
Disconnect all external cables from the printer to prevent possible damage during service.
Unless otherwise stated, reinstall the parts in reverse order of removal.
When reinstalling a part held with several screws, start all screws before the final tightening.

Base printer - cover removals

"Column left front cover removal (MX81x)" on page 291
"Column left outer cover removal (MX81x)" on page 292
"Column right inner cover removal" on page 294
"Column right outer cover removal" on page 295
"Left cover removal (MX71x)" on page 296
"Left cover removal (MX81x)" on page 298
"Left inner cover removal" on page 300
"Rear door removal" on page 302
"Rear lower cover removal" on page 304
"Rear lower door removal (MX81x)" on page 305
"Right cover removal (MX71x)" on page 306
"Right cover removal (MX81x)" on page 307
"Right inner cover removal (MX71x)" on page 308
"Top cover removal" on page 309

Column left front cover removal (MX81x)

1
Remove the controller board access cover. See
2
Remove the rear door. See
3
Remove the left cover. See
4
Open the front door.
5
Open the cartridge door.
279.
"Rear door removal" on page
"Left cover removal (MX81x)" on page
Repair information
"Controller board access cover removal" on page
302.
298.
291
"Media aligner roller
"Configuration menu" on
373.
7463

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx71 series

Table of Contents