Siemens ET 200SP Manual page 169

Parameter data record
A.2 Parameter validation errors
Error codes
The following table shows the module-specific error codes and their meaning for parameter
data record 128.
Table A- 7 Error codes for parameter validation
Error code in STATUS parame-
ter (hexadecimal)
Byte 0 Byte 1 Byte 2 Byte 3
DF 80 B0 00
DF 80 B1 01
DF 80 B2 00
DF 80 E0 01
DF 80 E0 02
DF 80 E1 00
DF 80 E1 11
DF 80 E1 12
DF 80 E1 18
DF 80 E1 19
DF 80 E1 1A
DF 80 E1 1B
DF 80 E1 1C
DF 80 E1 1D
DF 80 E1 1E
DF 80 E1 20
168
Meaning
Data record number unknown
Length of data record incorrect
Slot invalid or not available
Wrong version
Error in the header information
Parameter invalid: No detailed information
available
"Operating mode" parameter invalid
"Reaction to CPU STOP" parameter invalid
"Set function of DI" parameter configured the
same for DI0 and DI1.
"Edge selection" parameter invalid
•
"Gate start (edge-triggered)" configured as
•
function for DIm and "At rising and falling
edge"
"Gate stop (edge-triggered)" configured as
•
function for DIm and "At rising and falling
edge"
"Synchronization" configured as function for
•
DIm and "At rising and falling edge"
"Input delay" parameter invalid
Value above the high limit of the parameter
"Period duration"
Value above high limit of parameter "On delay"
Value above high limit of parameter "Minimum
pulse duration"
Value above high limit of parameter "Off delay"
Value above high limit of parameter "Reference
value current"
Solution
Enter valid number for data record.
Enter valid value for data record length.
Check whether module is inserted or removed.
•
Check assigned values for parameters of the
•
WRREC instruction.
Check byte 0.
•
Enter valid values.
•
Check byte 1.
•
Correct the length of parameter blocks.
•
Check all parameter values.
Enter valid parameter value.
Enter valid parameter value.
Enter different parameter values for DI0 and DI1.
Enter valid parameter value.
•
Configure "Gate start (edge-triggered)" as function
•
for DIm only together with "At rising edge" or "At
falling edge"
Configure "Gate stop (edge-triggered)" as function
•
for DIm only together with "At rising edge" or "At
falling edge"
Configure "Synchronization" as function for DIm
•
only together with "At rising edge" or "At falling
edge"
Enter valid parameter value.
Enter a parameter value of maximum 85000000
Enter a parameter value of maximum 85000000
Enter a parameter value of maximum 85000000
Enter a parameter value of maximum 85000000
Two-channel operation: Enter parameter value of
maximum 2000 .
D
One-channel operation: Enter a parameter value of
maximum 4000 .
D
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
.
D
.
D
.
D
.
D