Handling Of The Slot Parameters - Siemens ET 200SP Manual

4.10

Handling of the SLOT parameters

In addition to the main setpoint OUTPUT_VALUE, you can change a setpoint for another
parameter.
You specify the load value with the SLOT value in the control interface. You use the
LD_SLOT load request to specify the meaning of the value in SLOT depending on the
operating mode:
LD_SLOT
In so doing, you use the MODE_SLOT control bit to choose whether you want to apply a
change of the respective value once or cyclically.
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
Meaning of the value in
SLOT
0 No action, idle
D
1 Period duration
D
2 On delay
D
3 Off delay
D
4 Duty cycle
D
5 Dithering ramp up,
D
ramp down
6 Dithering amplitude
D
7 Dithering period duration
D
4.10 Handling of the SLOT parameters
Operating modes for use of the value
All operating modes
Pulse width modulation PWM
•
Pulse train
•
PWM with DC motor
•
Pulse output
•
Pulse width modulation PWM
•
Pulse train
•
Frequency output
•
PWM with DC motor
•
On/Off delay
•
Pulse train
•
Pulse width modulation PWM
•
Pulse width modulation PWM
•
Pulse width modulation PWM
•
Configuring/address space
Data type of
SLOT
—
UDINT
2 × INT
UDINT
139