System Clean Up And Labeling; Notifying The Help Desk As Ready For Configuration - Avaya S6200 Manual

Installing S6x00 Hardware

System Clean Up and Labeling

To clean up and label the system, follow these steps:
1. Label all hardware with name and IP address.
2. Label each end of each cable, except network cabling, with where it comes from and where
it connects to.
3. Make sure there are no loose cables or wires hanging from the system. This could cause
injury to personnel or the system if a cable is accidentally pulled. All cables should be tie
wrapped neatly.
4. Physically inspect the system and general area to ensure no parts, shipping material,
cables, or debris are left behind.

Notifying the Help Desk as Ready for Configuration

When all of the installation tasks have been completed, notify the Help Desk that the system is
ready for remote configuration.
!
Important:
Notify the Help Desk of any changes or inconsistencies you have found in IP
Important:
addresses, telephone numbers, and other items specified on the Site Survey.
44 Installing the S6200, S6500, and S6800 Conferencing Server