Avaya S6200 Manual page 24

Installing S6x00 Hardware
24 Installing the S6200, S6500, and S6800 Conferencing Server
Attach the front rail bracket to the rack:
Press the tab _2_ away from the rail. Slide the
front rack-bracket pins _1_ away from the
rail-mount flange_3_ until the front rail bracket
stays open. Place the rack-mount flange
_4_between the front rack-bracket pins _1_and
the rail-mount flange_3_. Press the tab
_2_away from the rail. The pins snap forward
and extend through the rack-mount flange and
the rail-mount flange.
Attention: Make sure that the rail is securely
clamped against the rack-mount flange.
Insert the server into the rack cabinet:
Align the server on the slide rails and push the
server into the rack cabinet. If the rail-lock pins
are extended out, pull the side release latches
toward you, which lifts up the rail-lock pins. Push
the server into the rack the remainder of the
way. Install the cable-management arm: Insert
the cable-management arm into the five slots in
the rear of the server. When the
cable-management arm is inside all five slots,
slide the cable-management arm to the left by
pulling the locking