Avaya S6200 Manual page 23

Installing the S6200 Application Server
To install the S6200 Application Server, follow these steps:
Slide the pins away from the rail-mount
flange:
Press behind the slide-rail release latch _1_
and hold it to prevent the rail from sliding
back. Press the tab _2_ away from the rail.
Press the tab _3_ back, and slide the rear
rack-bracket pins away from the rail-mount
flange_4_. Slide the pins back until the
bracket stays in an open position.
Attention: Do not remove tab _5_unless
you are installing the rails on a non IBM
rail-mount flange with a thickness greater
than 3.175 mm (0.125 in.). If you remove tab
_5_, you must insert an M6 screw through
the top and bottom holes of the rail-mount
flange _4_ on all four flanges of the rack.
Attach the rear rail-adjustment bracket to the
rack:
Place the rack-mount flange _1_ between
the rail-mount flange and the rack-bracket
pins. Press the tab _2_; the rack-bracket
pins snap into place, sliding through the
rack-mount flange_1_ and rail-mount flange.
Lift the slide-rail release latch _3_, and then
slide the front rail toward the front of the
rack.
Attention: Make sure that the rail is securely
clamped against the rack-mount flange.
Issue 1 July 2006 23