Avaya S6200 Manual page 55

Client MAC Address
Subnet
Gateway
TFTP Server IP
Boot File
INI File
2. Enter the MAC Address that matches the Gateway card and check the box beside it as
shown above.
3. Type "XXXX" in Client name.
4. Leave Template as <none>.
5. Enter the IP Address, Subnet mask, and Gateway IP Addresses in their respective fields.
6. Enter your laptop's IP address in the TFTP Server IP Field.
7. Click OK.
8. Click Apply.
9. Click Reset.
10. Wait approximately15 seconds or so and then close this window.
11. Restart the S6200 Application Server and Audio Gateway card. Notice the log entry that
displays the client information in the log window on BootP.
!
Important:
Verify that you are only accessing the gateway card. The MAC Address on
Important:
Gateway board should match the client's MAC Address on the log received by
the BootP application.
This concludes the configuration step. Request that the Avaya Support complete the
configuration.
Gateway Card MAC Address
Subnet Mask
Boards Gateway IP Address
TFTP Server Machine IP Address
*.cmp file which is gateway software image file
*.ini file which is gateway parameters configuration file
Configuring the Gateway
Issue 1 July 2006 55