Mounting The Panel - Interlogix Simon XT Installation Manual

Figure 3: Opening the panel cover and chassis

Mounting the panel

To mount the panel on a wall, do the following:
1. Choose a panel location.
2. Run all necessary power, phone, siren, and hardwired contact wires to the
desired panel location.
Note: When choosing the AC outlet location for the AC power transformer,
make sure the outlet is not controlled by a switch or that it is not part of a
ground fault circuit interrupt (GFCI).
3. Hold the panel against the wall and mark the mounting hole locations with a
pencil.
4. Mount the back piece to the wall through the two horizontally centered
mounting holes near the top and bottom using the supplied mounting
hardware. Use wall anchors if no studs are present (Figure 4 on page 22).
Simon XT Installation Manual 21