Dual Mode - Barco Hydra User Manual

4.4 Dual mode

In dual mode one H
YDRA
to display the sources of the H
Mode. To enable dual mode the H
output card.
One channel output card
Each output card is connected to one projection module. The first output card in the order they are inserted into
the H C (left one, if looking from front on the H
YDRA OMPACT
the second output card must be connected to the right projection module. The figure below demonstrates the
cabling in dual mode:
DVI-DVI output card
With the DVI-DVI output card in dual mode each connector of the card is used to provide data for one projection
module. Channel one (the upper connector) is connected to the left projection module (looking from front to the
projection modules) channel two is connected to the right projection module, please see also the figure below:
Barco – Hydra – R5976260 – Revision 10 – February-2004
is connected to two projection modules. A special setting of the iS
on both modules, please refer also to the iS
YDRA
must be equipped with two one channel output cards or with one DVI-DVI
YDRA
Output Card 1
Channel 1
_______________________________________________________________________________________________________
) must be connected to the left projection module,
YDRA
Display Wall
Output Card 2
Hydra
Scheme of dual mode connection for one channel output cards
Display Wall
Channel 2
Output Card
Hydra
Scheme of dual mode connection for DVI-DVI output cards
4. Operating
software allows
TUDIO
user's manual, section
TUDIO
Dual
Figure 4-2
Figure 4-3
4-6