Table of Contents
Advertisement
The Back
The back of your H
looks like this or similar:
YDRA
12
single board computer
13
overlay input
14-27 7
video and RGB input cards
28
output card
29
audio input card
30
green LED, power failure
31
red LED, fan failure
32
buzzer reset button
33
mains connection 1
34
mains connection 2
35
power module 1
36
power module 2
37
power module 3
38
power module 4
All boards are inserted in the upper part of the back of H
[12] and the overlay input card [13]. Next to them there are 16 slots available to integrate the various cards.
From right to left there are the SDI video cards, HD-SDI video input cards, RGB input cards and the analog
video cards [14 4 -27]. Finally there is the output card [28] and the audio input card [29].
On the lower part of the back of H
connection [33, 34]. Here with two power cables two independent power nets can be connected. Over the dual
mains connection there is the buzzer reset button [32], the red LED [31] to indicate a fan failure and the green
LED [30] to indicate a power failure. On the left hand side there are four hot swap power modules [35 5 -38].
To protect H
obstructions. A space of at least 1U between top and bottom respectively to the adjacent
devices must be left!
Barco – Hydra – R5976260 – Revision 10 – February-2004
the power supply is located. On the right hand side there is a dual mains
YDRA
from overheating, the air supply openings in the case shall be kept free of
YDRA
1U between top and bottom respectively to the adjacent
_______________________________________________________________________________________________________
. On the right there is the single board computer
YDRA
3. Getting started
Figure3-2
Rear view of H
YDRA
3-4
Advertisement
Table of Contents
