3.2 Cabling
3.2.1 Power supply
Check the power rating on your outlet before connecting
power strip. Contact your facilities manager or a qualified electrician if you are not sure
what type of power is supplied to your building.
H
is designed to operate with single-phase power systems having a grounded neutral
YDRA
conductor. To reduce the risk of electrical shock, do not plug into any other type of power
system.
The H
has a dual power input therefore two power nets can be connected. To connect H
YDRA
supply, follow these steps:
•
If your power module is equipped with a voltage selector (only the 600W power supplies have a voltage
selector), select the appropriate type of power with the voltage selector on the back of the power module.
You can choose between low range (100 – 125 VAC) or high range (200
power module from the H
out voltage selector perform a voltage auto range.
•
Plug the female end of the one power cord into the mains connection [33].
•
Plug the female end of the other power cord into the mains connection [34].
•
Plug the male end of both power cords into the two designated power outlets.
Barco – Hydra – R5976260 – Revision 10 – February-2004
your outlet before connecting H
quipped with a voltage selector (only the 600W power supplies have a voltage
is explained in detail in section
YDRA
_______________________________________________________________________________________________________
YDRA
C) or high range (200 – 240 VAC). How to remove the
5.1.1 Exchange of the power
3. Getting started
to the wall outlet or to a
to the power
YDRA
module. Models with-
Figure 3-4
Voltage selector
Figure 3-5
Mains connection of H
YDRA
3-6