Table of Contents
Advertisement
3. Getting started
3.3 Starting up
3.3.1 Connecting g
First of all you have to provide the appropriate power supply. Plug in the power cable on the back panel of your
H
. Please, refer to section
3.2.1 Power
supply!
YDRA
Connect your H
to the local area network! Connect the network to the Ethernet connector of the single board
YDRA
computer! Please, refer to section
3.2.2 Single board
computer!
Connect your video sources to the video input cards, if advisable use the patch panel. Please, refer to section
3.2.4 Video input card
and
3.2.9 Patch
panel! Connect your RGB sources to the RGB input cards. Please, refer to section
3.2.5 RGB input
card! If the RGB signal is provided by a cable with BNC connectors, also the patch panel can be
used.
Connect the intended display devices to the output card. Please, refer to section
3.2.6 Output
card!
If necessary, connect the audio sources to the digital and analog audio daughter boards. Please, refer to section
3.2.7 Audio board
and
3.2.8
Parthenope!
______________________________________________________________________________________________________
Barco – Hydra – R5976260 – Revision 10 – February-2004
3-26
Advertisement
Table of Contents
