Table of Contents
Advertisement
3.3.2 Switching on
When taking the H
YDRA
ROM drive. Therefore follow the above mentioned steps:
•
To switch on the H
YDRA
•
Check the state of the green LED power [30] on the back of H
that the power supply operates properly. If this is not the case, see section
•
Open the CD-ROM drive [7]. If the CD-ROM drive does not stay open, retry opening it until it stays open.
•
Insert the iS
CD in the drive and close it.
TUDIO
•
Switch off the H
YDRA
•
Switch it on again.
If the iS
CD-ROM is already in the CD-ROM drive then just:
TUDIO
•
Press the power switch [6] on the front of H
•
Check the state of the green LED pow
k the state of the green LED power [30] on the back of H
that the power supply operates properly. If this is not the case see section
Now the H
starts booting from the iS
YDRA
logo together with the IP address of the H
has been configured also another startup screen could appear, dependent on the configuration of the startup
layout.) As soon as the start screen is displayed, the H
erator PC to the H
YDRA
user's manual.
Barco – Hydra – R5976260 – Revision 10 – February-2004
for the first time into operation, first the iS
, press the power switch [6] on the front of H
with the power switch [6].
CD. The startup screen is displayed. By default it shows the Barco
TUDIO
, which is displayed in the upper left corner. (If the
YDRA
can be established. This and any further operation is explained in detail in the iS
______________________________________________________________________________________________________
TUDIO
YDRA
. It must be permanently on to indicate
It must be permanently on to indicate
YDRA
.
YDRA
. It must be permanently on to indicate
YDRA
is ready for operation and a connection from an op-
YDRA
3. Getting started
CD ROM must be i
D ROM must be inserted into the CD-
.
7.1 Hydra does not start up
7.1 Hydra does not start up
(If the H
H
please.
please.
already
YDRA
TUDIO
Figure 3-23
startup screen
YDRA
3-27
Advertisement
Table of Contents
