Table of Contents
Advertisement
4.1.2 BIOS settings
The table below lists the H
566 MHz processor speed: :
path
Inside Utilities -> Display Setup -> Embedded VGA/LCD/TV Type
Inside Utilities -> Display Setup -> Set Panel Type
For an SBC with 233 MHz processor speed there are multiple scenarios depending on the overlay input version of
the overlay input card and on the output resolution of the H
1.6 6 on:
path
processor clock
Display Type
SDD-DRIVE
PANEL DRIVER -> Resolution
PANEL DRIVER -> Technology
PANEL DRIVER -> Manufacture
PANEL DRIVER -> Code
Take care not to use the entry »default settings« as this applies other settings than
mentioned above. Nevertheless if so, please readjust the BIOS to the above Hydra settings!
4.1.3 Finishing the BIOS changes
•
After selecting the appropriate settings save the settings and exit the BIOS.
•
Halt the H
and switch it off again, see above.
YDRA
•
Now you can safely disconnect monitor and keyboard from the SBC.
•
The H
can be taken into its usual operation again.
YDRA
Barco – Hydra – R5976260 – Revision 10 – February-2004
specific BIOS settings that must be selected for proper operation of the SBC with
YDRA
settings
overlay version 9 or higher
or
overlay version 8 or lower with SXGA
or UXGA output of Hydra
233/66 MHz z
CRT & PANEL
M-SYSTEM
1280x1024
80x1024
TFT color
Standard
1280x1024TFT
»default settings« as this applies other settings than
ppropriate settings save the settings and exit the BIOS.
_______________________________________________________________________________________________________
setting
CRT1 + LCD
1280x1024
TFT Color
FT Color
IBM
ITSX94
. The below values are valid from iS
YDRA
overlay version 8 or lower with XGA
output of Hydra
233/66 MHz
CRT & PANEL
M-SYSTEM
1024x768
TFT color
Samsung
msung
LT151X1-2
4. Operating
Table 4-1
BIOS settings of SBC 566 MHz
release
TUDIO
Table 4-2
BIOS settings of SBC 233 MHz
4-3
Advertisement
Table of Contents
