Preparing peripheral devices
DIP switch
8
Setting the CD-ROM drive SCSI ID and DIP switches
Introduction
This section describes how to set the CD-ROM drive SCSI ID and DIP switches.
Important:
You must power down the CD-ROM drive before changing the SCSI ID and DIP switches.
Note:
The CD-ROM drive discussed in this section is the external SCSI CD-ROM drive
(NTRH9037).
To set the CD-ROM drive SCSI ID
The SCSI ID setting is located on the back of the CD-ROM drive. (See the diagram that follows.)
To change the SCSI ID, use the blade of a screwdriver to rotate the SCSI ID dial arrow to 3.
®
98
Avaya CallPilot
201i Server Hardware Installation
Default setting
• OFF: Loads Y or Y1 configuration from user-
defined nonvolatile memory (NVRAM)
• ON: Loads &F0-Generic template from read-only
memory (ROM)
ON
AT command set recognition
• OFF: Disables command recognition (dumb mode)
• ON: Enables recognition (smart mode)
Function
December 2010