Table of Contents
Advertisement
Connecting peripheral devices to the 201i server
To connect the CD-ROM and tape drives to the 201i server
(Meridian 1)
Note:
If you are connecting the SCSI devices to the Option 11C, go to
and tape drives to the 201i server (Option 11C)
devices to the Option 11C Mini, go to
server (Option 11C Mini)
1. Connect the first SCSI device.
2. Follow instructions below:
3. Connect the low-profile right-angle SCSI cable connector to the SCSI connector on
4. Connect an additional device in a daisy chain, if required, using either the SCSI
®
116
Avaya CallPilot
on page 118.
IF the first device is the
CD-ROM drive
tape drive
the 201i server faceplate.
cable supplied with the device or an NTRH3502 cable.
The following diagram shows cable connections, where the CD-ROM is the first
device:
201i Server Hardware Installation
on page 117. If you are connecting the SCSI
To connect the CD-ROM and tape drives to the 201i
THEN
connect the CD-ROM drive to the NTRH1410
cable that you connected earlier to the Meridian
1 I/O panel.
do the following:
a. Attach the A0769312 SCSI adapter to the
tape drive.
b. Connect the SCSI adapter to the NTRH1410
cable that you connected earlier to the Meridian
1 I/O panel.
To connect the CD-ROM
December 2010
Advertisement
Table of Contents
