Table of Contents
Advertisement
Connecting peripheral devices to the 201i server
Starting the 201i server
When you lock the 201i into position against the switch backplane, the server starts
automatically. You can observe the startup process on both the monitor and the 201i server
faceplate.
Important:
Ensure that all peripheral devices are connected before you lock the 201i server in position
against the backplane.
The 201i server receives power and starts when the connection with the backplane is
established.
Before you begin
Before you connect the peripheral devices, ensure that you have completed the following tasks:
1. Set the DIP switches on the external fax modem. See
2. Prepare the SCSI CD-ROM and tape drives. See the following:
Installing the MPCs
Introduction
Two MPCs are preinstalled at the factory. This section describes how to install additional cards,
if required.
®
110
Avaya CallPilot
switches
on page 96.
•
Setting the CD-ROM drive SCSI ID and DIP switches
•
Setting the tape drive SCSI ID
•
Setting SCSI device termination
201i Server Hardware Installation
Setting the modem DIP
on page 100
on page 101
on page 98
December 2010
Advertisement
Table of Contents
