Table of Contents
Advertisement
About the 201i server
Faceplate feature
Network and drive activity
LEDs (labeled as E, C, I,
and S)
Reset button
Environmental specifications
Temperatures
Recommended temperature
Absolute temperature
Long-term storage temperature
Short-term storage temperature
Change rate temperature
Relative humidity
Recommended relative humidity
(RH)
Absolute RH
Long-term storage RH
®
18
Avaya CallPilot
201i Server Hardware Installation
The E and C LEDs indicate the presence of network activity for
both the ELAN and CLAN interfaces (respectively). When they
are lit, they indicate that the interfaces are properly attached to
their respective hubs. When the LEDs are blinking, there is
network activity.
When the I and S LEDs are lit, it means that the IDE hard drive
and SCSI device are being accessed.
The reset button allows you to manually restart the 201i server
without disconnecting it from the backplane.
Important:
Before you press the reset button, you must shut down the
operating system. Press the reset button while the operating
system is running only when you cannot shut down the
operating system normally.
15°C (59°F) to 30°C (86°F)
10°C (50°F) to 45°C (113°F)
-20°C (-4°F) to 60°C (140°F)
-40°C (-40°F) to 70°C (158°F) (less than 72 hours)
Less than 1°C (34°F) per 3 minutes
20% to 55% RH (noncondensing)
20% to 80% RH (noncondensing)
5% to 95% RH [at -40°C (-40°F) to 70°C (158°F)
respectively] (noncondensing)
Description
December 2010
Advertisement
Table of Contents
