Page 114 of 212
NN43021-461
Standard 06.03
Performing the upgrade
(the short harness attached to the module power connector) into
connector J3 on the MPDU (attached to the side of the card cage).
CAUTION — Service Interruption
Damage to Equipment
Check for and remove any debris (such as screws) that
may have fallen into the base of the UEM module.
Figure 26
Location of the screws for the MPDU
MPDU
wall inside
power supply
slot
b.
In DC-powered systems, connect the module power connectors to
each other.
c.
Attach the system monitor ribbon cables:
i.
Connect the ribbon cable that goes down to the column to
connector J1 on the backplane.
ii.
Connect the ribbon cable that goes up the column to J2 on the
backplane.
June 2014
back plane
MPDU
mounting screws
card cage
553-5890