Table of Contents
Advertisement
d.
Use a 11/32" socket wrench to attach the green ground wire to the
frame ground bolt on the module. Remove the nut and the lock
washer at the top of the bolt. Put the frame ground wire terminal over
the bolt. Reinstall the top lock washer and the nut, then tighten down
the nut.
Note: For all of the wire terminals to fit on the bolt, remove one of the lock
washers. Leave the first lock washer at the bottom of the bolt and a
second at the top of the bolt. Leave a third lock washer between the
second and third, or the third and fourth, wire terminals.
e.
Attach the orange logic return wire. Remove one nut and the lock
washer from the LRTN bolt at the rear of the card cage. Put the wire
terminal over the bolt, reinstall the lock washer and nut. Use a 1/4"
socket wrench to tighten down the nut.
5
Slide the card cage all the way into the module.
6
Check the position of the EMI shield. If the EMI shield has shifted,
reposition it. Remove the tape holding the EMI shield.
7
Secure the card cage and EMI shield to the module re-using the existing
screws.
8
Preroute cables NT4N88AA, NT4N88BA and NT4N90BA.
a.
Route cable NT4N88AA from COM1 on the CP PIV faceplate to J25
on the I/O panel. (NT4N88AA is used to connect a terminal.)
b.
Route cable NT4N88BA from COM2 on the CP PIV faceplate to J21
on the I/O panel. (NT4N88BA is used to connect a modem.)
9
Route cable NT4N90BA from LAN 1 on the CP PIV faceplate to J31 (top)
of the I/O panel.
10 Do not connect the NTRC17BA crossover ethernet cable at this time.
Performing the upgrade
End of Procedure
61C to CS 1000M SG CP PIV Upgrade
Page 115 of 212
Advertisement
Table of Contents
