Table of Contents
Advertisement
Page 120 of 212
Table 18
Clock Controller switch settings for QPC471H, QPC771H (Part 2 of 2)
Systems upgraded to CP PIV must use the Meridian 1 Option 61C CP PIV switch
settings to enable Clock Hunt software. Use the settings in this table.
SW1
1
2
3
4.6–6.1 m (15–20 ft.)
6.4–10.1 m (21–33 ft.)
10.4–15.2 m (34–50 ft.)
** Set to ON for Clock Controller 0. Set to OFF for Clock Controller 1.
Install the Security Device
NN43021-461
Standard 06.03
Performing the upgrade
4
1
Procedure 33
Installing the Security Device
The Security Device fits into the System Utility card (see Figure 28 on
page
121).
To install the Security Device:
1
If the original system had an IODU/C, remove the Security Device from
the IODU/C for reuse.
a.
Unlock the latches and remove the IODU/C card.
b.
Remove the round 1/2" diameter IODU/C Security Device from the
round black Security Device holder on the top right corner of the
IODU/C card.
OR
If the original system did not have an IODU/C, use the Security
Device provided with the CP PIV Software kit.
June 2014
SW2
2
3
4
End of Procedure
SW4
1
2
3
off
on
on
4
on
off
on
Advertisement
Table of Contents
