Installing A Port Module - Juniper SRX 5600 Installation Instructions Manual

SRX 5600 and SRX 5800 Services Gateway Flex IOC and Port Module Installation Instructions

Installing a Port Module

To install a port module (see Figure 9 on page 14):
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 9: Installing a Port Module
10.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
14
Replacing Flex IOCs and Port Modules
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see Preventing Electrostatic Discharge Damage" on page 16.
If you have not already done so, install the flex IOC in which you are installing
the port module, as described in Installing a Flex IOC" on page 11.
Place the port module on an antistatic mat or remove it from its electrostatic
bag.
Verify that each fiber-optic transceiver is covered with a rubber safety cap. If it
is not, cover the transceiver with a safety cap.
If necessary, remove the blank panel covering the slot in the flex IOC where you
are installing the port module.
Orient the port module so that the faceplate faces you.
Lift the port module into place and carefully align the sides of the port module
with the guides inside the flex IOC.
Slide the port module all the way into the flex IOC until it is fully seated.
Tighten both captive screws to secure the port module in the flex IOC.
If the port module uses fiber-optic interfaces, remove the rubber safety cap from
each transceiver and cable.