Replacing The Compactflash Card; Replacing The Phase Module Or Diode Module; Attaching The Changing Device To The Stacker - Siemens Sinamics GM150 6SL3835-2LN44-2AA0 Operating And Installation Instructions

Maintenance
9.5 Repair
9.5.4

Replacing the CompactFlash card

To replace the CompactFlash card, proceed as follows:
1. Ensure that the Control Unit is de-energized.
2. Withdraw the CompactFlash card from the Control Unit. Back up the data saved on it.
3. Copy the stored data of the previous CompactFlash card to the new original Siemens card.
4. Insert the new Siemens CompactFlash card.
9.5.5

Replacing the phase module or diode module

9.5.5.1

Attaching the changing device to the stacker

Danger to life due to a falling module
If the component to be replaced phase falls from the roller conveyors of the changing device,
death or serious bodily injury can result.
For your personal safety, please always follow these instructions:
● Secure the lifting trolley using the brake.
● Handle and install the changing device according to the appropriate regulations.
● Secure the component to be replaced.
● Never position yourself under the component to be replaced when rolling it in and out.
196
NOTICE
Destruction of the CompactFlash card
The CompactFlash card must only be inserted or removed when the power is off.
Otherwise there is a risk of data loss or damage to the card, which would prevent
commissioning of the drive.
● Only remove or insert the CompactFlash card when the power is switched off.
Note
Invalid software key
The software key is associated with the serial number of the CompactFlash card. If you
overwrite the software key of the new CompactFlash card with the previous CompactFlash
card, the new CompactFlash card is not operational.
Consequently, use the software key of the new CompactFlash card.
WARNING
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER