Replacing The Compactflash Card; Replacing The Diode Module - Siemens SINAMICS GM150 Operating Instructions & Installation Instructions

9.5.4

Replacing the CompactFlash card

To replace the CompactFlash card, proceed as follows:
1. Ensure that the Control Unit is de-energized.
2. Withdraw the CompactFlash card from the Control Unit. Back up the data saved on it.
3. Copy the stored data of the previous CompactFlash card to the new original Siemens card.
4. Insert the new Siemens CompactFlash card.
9.5.5

Replacing the diode module

The Basic Line Module comprises several diode modules. The diode module is a replaceable
unit. A diode module weighs 19 kg. It takes experienced personnel 20 min. to replace the diode
module.
Required tools
● 10 mm open-ended wrench or socket wrench
● 13 mm open-ended wrench or socket wrench
● Torque wrench
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE
NOTICE
Destruction of the CompactFlash card
The CompactFlash card must only be inserted or removed when the power is off.
Otherwise there is a risk of data loss or damage to the card, which would prevent
commissioning of the drive.
● Only remove or insert the CompactFlash card when the power is switched off.
Note
Invalid software key
The software key is associated with the serial number of the CompactFlash card. If you
overwrite the software key of the new CompactFlash card with the previous CompactFlash
card, the new CompactFlash card is not operational.
Consequently, use the software key of the new CompactFlash card.
Maintenance
9.5 Repair
191