Repair - Siemens Sinamics GM150 6SL3835-2LN44-2AA0 Operating And Installation Instructions

Medium-voltage drive
Table of Contents

Advertisement

Maintenance

9.5 Repair

3. Using "F2", select the menu item "AOP30 settings". Confirm with "F5"
4. Using "F2", select the menu item "Set date/time". Confirm with "F5". Using "F2", select the
5. Use "F5" to save the settings.
9.5
Repair
Burns caused by inadequate cable insulation
Improperly laid or damaged cables and incorrectly attached cable shieldings can heat up in
places and cause fires or short-circuits wherever they make contact.
● Check whether all the cable shields are intact.
● Insulate damaged cable shields.
● Make sure that a short-circuit cannot occur on the power cables due to failure of the
NOTICE
Damage if the auxiliary power supply is not available
When the auxiliary power supply is switched off, data about error message statuses can be
lost. Inadequate diagnostic and error rectification measures can result in material damage.
● We recommend using an uninterruptible power supply (UPS). If you are unsure of the
After performing repairs, refasten all cable ducts whose cover faces downward with a cable tie.
The cable ties must be located at the same positions as in the delivered state. You will find more
information in "Fastening the cable ducts with cable ties (Page 99)".
Note
Special investigation of defective components
You can return defective components, e.g. phase modules, PowerCards, etc. for a special
investigation. You can find more information here
support.automation.siemens.com/WW/llisapi.dll?aktprim=1&lang=en&referer=%2fWW
%2f&func=cslib.csinfo&siteid=csius&nodeid1=17218131&treeLang=de&groupid=4000002&e
xtranet=standard&viewreg=WW&objaction=csopen).
192
appropriate input location for date or time. Enter the actual value using the numerical keys.
WARNING
insulation as a result of incorrect cable installation.
measures necessary after the device fails, or if a fault cannot be rectified, contact the
Service Center.
(http://
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents