Installation
5.7 Connecting the DC bus
①
②
Figure 5-5
Reattach the dust protection for the DC bus
1. Shift the insulating strips over the center connection of the DC bus (1 x insulating strip A
2. Using a cable tie
82
Insulating strips
Connection jumper
Connecting the DC bus
front, in the viewing direction; 2 x insulating strips B rear, in the viewing direction).
③
, bind the insulating strips at the bottom. Cut off any excess cable tie
length.
③
DC bus
④
Bracket
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER