Removing / Fitting The Casing; Position The Heat Generator And Cylinder - Wolf COB-2 Operation Instructions Manual

Installation
5.3 Removing / fitting the casing
Removing the casing
Fig. 5.2 Removing the casing
► Undo the screws (1).
► Tilt the panel forwards (2).
► Remove the casing cover upwards (3).
Attaching the casing
Fig. 5.3 Attaching the casing
► Insert the casing cover (1).
► Put the panel in place (2).
► Tighten the screws (3).
5.4

Position the heat generator and cylinder

Maintain minimum wall clearances! This will simplify installation, maintenance and servicing
i
Minimum wall clearances to the front and
► Remove the casing
► Use the adjustable feet to level the heat generator and cylinder
3066501_201910
q
w
w
(Fig. 5.2 Removing the
e
e
q
w
q
1.
q
1.
e
e
w
side).
casing).
(4.2.1
WOLF GmbH | 31