Installation
Fig. 5.9
Connection set on heat generator
5.6
Connect the cold water
► Check operating pressure (maximum 10 bar).
If operating pressure is higher:
► install a tested and approved pressure reducer.
When using mixer taps:
► install a central pressure reducer.
► Observe the regulations of DIN 1988 [Germany] as well as those of your local water supply utility when
connecting cold water and DHW.
Failure to observe
warranty.
Parallel DHW operation is not possible for heat generators with a TS stratification cylinder. If the
i
system parameter (A10: enable parallel mode) is set to parallel DHW operation despite this, the
heating circuit pump will not be activated during cylinder heating.
34 | WOLF GmbH
Fig. 5.10 Cold water connection to DIN 1988
in the installation voids any WOLF GmbH
3066501_201910