Ground Wire - Stihl MS 362 Manual

1
The wire must be laid straight.
: Push the short circuit wire (1) into
the guides (arrows).
– Install the filter base, b 12.3
: Push the ring terminal (1) onto
the pivot pin (arrow) as far as
stop.
1
: Push the short circuit wire (1) into
the guides (arrows).
Position the short circuit wire so that
it forms a loop and can move along
with the switch shaft.
56
: Check that short circuit wire is
properly seated, push it fully into
the guide (arrow) if necessary.
1
: Fit the ring terminal (1) of the
ground wire on the pin (2) and
swing it down.
2
: The ring terminal (1) must
engage behind the lug (2).
– Fit the contact spring, b 7.7.4
: Push the ground wire (1) into the
guide (arrow).
– Reconnect the choke rod,
b 10.3.3
– Reassemble all other parts in the
1
reverse sequence.
– Tightening torques, b 2.5
2
7.7.3
A faulty ground wire may impair or
prevent operation of the short circuit
wire.
The ground wire is combined with
the short circuit wire in a wiring
1
harness. If damaged, the complete
wiring harness must be replaced
– Check for contact and continuity
and replace the short circuit wire
if necessary, b 7.7
1

Ground Wire

MS 362, MS 362 C