Removing And Installing - Stihl MS 362 Manual

7.7.2

Removing and Installing

– Pull the boot off the spark plug,
b 5.2
– Remove the shroud, b 6.4
– Remove the fan housing,
b 8.2
– Disconnect the choke rod,
b 10.3.3
– Remove the contact spring,
b 7.7.4
– Remove the filter base, b 12.3
The ground and short circuit wires
are combined in a wiring harness.
2
1
: Pull the ignition lead (3) out of the
guide (arrows).
: Remove the connector (1).
: Take out the screw and remove
the ground wire (2).
MS 362, MS 362 C
: Pull the wiring harness (1) out of
the guides (arrows).
3
: Pull the short circuit wire (1) out
of the guides (arrows).
– Remove the ring terminal from
the pivot pin (2).
: Swing the ring terminal (1) up and
remove it from the pivot pin (2).
– Remove the filter base, b 12.3
1
1
: Pull the short circuit wire (1) out
of the guides (arrows).
Installing
1
1
: Position the short circuit wire so
that the yellow mark lines up with
the edge (arrow) of the air baffle.
– Push the wiring harness (1) into
the guide.
1
2
: Position the short circuit wire (1)
so that the yellow mark (arrow) is
against the guide.
1
55