Stihl MS 362 Manual page 122

13.8 Wiring Harness
The wiring harness must be
replaced if it is faulty.
– Remove the shroud, b 6.4
– Remove the ignition module,
b 7.3
– Remove the carburetor, b 12.5
– Remove the thermostatic switch,
b 13.1.3
– Remove the carburetor carrier,
b 12.8
– Remove the interlock lever,
b 10.2, b 10.3
– Remove the filter base, b 12.3
1
2
: Pull the wire (1) and connector
(2) out of the guides (arrows).
MS 362, MS 362 C
1
: Push back the insulating tube (1)
in the direction of the generator
wire and separate the pin and
socket connector.
– Remove the air guide shroud,
b 12.4
1
: Tug the wiring harness (1) a little
to find the right connector.
1
: Push the insulating tube (1) in the
direction of the heating element
wire and separate the pin and
socket connector.
2
1
: Pull the wires (1) and the
insulating tube (2) out of the
guides (arrows).
2
1
: Pull the wiring harness (1) out of
the insulating tube (2).
: Pull the insulating tube (3) off the
wiring harness.
– Check the wiring harness and
insulating tubes and replace if
necessary.
3
121