Stihl MS 362 Manual page 114

1
: Unscrew the nut (1).
– Remove the washer.
: Remove the heater switch (1)
from inside, check and replace if
necessary.
Installing
1
: Position the heater switch with
the groove (arrow) facing up.
: Push the heater switch (1)
through the hole in the carburetor
box.
MS 362, MS 362 C
– Check operation.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
13.5 Heating Element in Rear
Handle
The ambient temperature during
removal and installation should not
be less than + 15°C.
1
– Remove the handle molding,
b 10.2
– Remove the interlock lever,
b 10.2
: Pull the wires out of the guides
(arrows).
1
: Push back the insulating tubes
(1) in the direction of the wiring
harness and separate the pin and
socket connectors.
: Check the heating element and
replace if necessary.
If the heating element is in good
condition the ohmmeter will indicate
a value of about 2 Ω in measuring
range "Ω".
If the reading is outside this range,
install a new heating element.
Heating element does not operate
even though resistance
measurement is ok?
– Test the generator and heater
switch, b 13.3
1
113