Stihl MS 362 Manual page 92

: Pull the wires out of the guides
(arrows).
2
1
: Take out the screws (arrows).
: Remove the air guide shroud (1)
and push the fuel hose (2)
through the opening at the same
time.
: Pull the wires out of the rubber
grommet.
MS 362, MS 362 C
1
: Remove the rubber grommet (1)
by pushing it into the air guide
shroud.
Installing
1
: Push the rubber grommet (1),
tapered end first, into the
housing.
: The flange (arrow) must locate
properly in the hole.
1
2
: Push wire (1) and then wire (2),
connector first, through the
grommet.
– Pull the full length of generator
wire (3) into the air guide shroud.
1
: Push the fuel hose (1) through
the opening (arrow).
1
3
: Fit the air guide shroud (1) over
the intake manifold (2), re-
positioning the fuel hose (3) at
the same time.
3
2
91