Adjusting - Stihl MS 362 Manual

2
3
: Hold lever (1) and lever (2)
together against the stop (arrow).
: Tighten down the screw (3) firmly.
– Check operation.
– Reassemble all other parts in the
reverse sequence.
MS 362, MS 362 C
12.6.6 Adjusting Screws
1
1
3
Grommet has been removed for the
sake of clarity.
There are three adjusting screws on
the carburetor:
H = high speed screw (1)
L = low speed screw (2)
LA = idle speed screw (3)
If the carburetor cannot be adjusted
properly, the problem may be the
adjusting screws.
The high speed screw H has a
limiter cap, which has to be
removed before the screw is
removed.
Always install a new limiter cap.
– Remove the carburetor, b 12.5
– See also carburetor
troubleshooting, b 3.6
1
: Pull off the grommet (1).
Low speed screw
2
1
: Take out the low speed screw (1).
1 2
3
– Inspect the sealing ring (1),
washer (2) and spring and
replace if necessary.
: Inspect the tip (arrow) for
damage or wear and replace the
low speed screw (L) if necessary.
– Screw down the low speed screw
(L) as far as stop.
– Continue with the high speed
screw.
99